Tunnel options -secret /etc/openvpn/test.key -dev-type tap -float -disable-occ In the example diagram above, the ImageStream Router will use the following configuration: For staticly addressed Windows clients, enter that address instead of "0.0.0.0" below. The configuration below assumes that the Windows PC uses a dynamic IP address. You will need to change the commands in the examples below to match the settings suitable for your network.Ĭonfiguring the ImageStream Router for an OpenVPN tunnelįor detailed information on the meaning of OpenVPN tunnel commands, please see the ImageStream Router Installation manual. Any device names, IP addresses, tunnel keys or bandwidth values are provided as examples. The configurations listed in this section may not match ones suitable for use on your network. Once traffic has arrived at the router, bandwidth usage has already happened and quality of service in the receive direction would have little effect. All Quality of Service rules are applied in the transmit direction. In the example below, we will use a network configuration that has a single local Ethernet segment and a single Serial device. For this example, we will use this configuration showing a point-to-point between an ImageStream router and a Windows PC running the OpenVPN client. ![]() The interface is configured similarly to a Serial WAN interface. OpenVPN tunnels are controlled by a virtual Tunnel interface configured in the interface configuration file. An ImageStream router's OpenVPN implementation can interoperate with any OpenVPN client on any operating system. ImageStream Linux 4.2 or later releases provide support for OpenVPN tunnels. Unlike CIPE tunnels or other tunnels supported by the ImageStream router, OpenVPN tunnels use the standard hardware and protocol status functions and may be used with configurations that rely on interface status. If your configuration requires dynamic routing (BGP, OSPF, RIP) or metric-based static routing failover configurations, you should use the OpenVPN SSL tunnels. An OpenVPN tunnel device is a standard network device and may be configured in the same manner as all physical devices and subinterfaces. The protocol is designed to be lightweight and simple, and to work seamlessly with dynamic addresses, NAT and SOCKS proxies. The SSL tunnel interface mode for Inetics devices uses the OpenVPN suite and allows IP packet tunneling inside encrypted UDP or TCP packets. A detailed explanation of basic SSL VPN configurations using the OpenVPN software on ImageStream routers is available in the ImageStream Router Installation Manual. ImageStream's version 4.2 releases include support for the highly secure SSL VPN tunnels. ![]() Connecting an SSL VPN between an ImageStream Router and a Windows PC Using OpenVPN
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |